Unidec Knowledgebase

ODT Troubleshooting

Use this forum for troubleshooting machine controllers

ODT Troubleshooting

Postby Unidec » Sun Oct 09, 2016 2:32 pm

This information pertains to 8221 (V2), 8222 (V3) and J11 (V4) machine controller systems typically found on through hole insertion machines.

For VCD sequencers that employ the ERV option; The inserter is normally machine #1, the sequencer is machine #2 and the ERV is machine #3

You can read the MIT card bit switches by entering the last address (followed by/) of the machine for any given MIT card.

Address Machine
7766036 1 (Inserter)
7766076 2 (Sequencer)
7766136 3 (ERV)

Toggle the run halt switch, you should see the @ symbol should appear. Now type in the MIT card address followed by a forward slash.

If the ERV is machine #2 in your system, enter

@7766076/100000 indicates machine 2 power on, no option bit switches set
__________^
machine power on bit

If the ERV is machine #3 in your system, enter

@7766136/100000 indicates machine 3 power on, no k5 jumpers in
__________^
machine power on bit

Note: the digits that are shown as zeros are normally not zero- a zero indicates that the bit switches are in the off position. You will need to set these switches according to the machine manual and your particular configuration.
Unidec
Site Admin
 
Posts: 61
Joined: Fri Jun 28, 2013 4:32 pm

Return to Controllers

Who is online

Users browsing this forum: No registered users and 0 guests

cron